![]() ![]() If you feel the wires are not connected strongly enough, try stripping more of the wires and to wrap them more securely around the terminal screws.Ģ. Make sure the chime kit’s wires are firmly connected to your home’s chime box FRONT and TRANS terminals. If the chime kit wires are not fastened securely, it’s possible the doorbell is not being supplied with enough power to run all its operations. Here are some options for a resolution to the problem:ġ. Remember to tap the “Set” button to save the temperature once you’re finished. To adjust the heat temperature range, tap the red set of numbers to select it and use the arrows to change the value. Use the Up or Down arrows to increase or decrease the cool temperature value. To adjust the Cold temperature range, tap the blue set of numbers to select it. To edit the Auto range, start by taping the “Edit” button on the app’s control screen. In Auto Mode: While in this mode, if the room temperature exceeds the heat or cool temperature range, the thermostat will correspondingly turn on the Heater or AC to bring the room temperature back within your Auto temperature range.Tap “Set” to lock the desired temperature. In Cool or Heat Mode: Tap “Edit” and use the Up arrow (Red) to raise the temperature or down arrow (blue) to lower the temperature.Tap the first tile (top left corner tile) to choose the mode. Login to the Momentum Smart Thermostat app and select your thermostat device’s tile to enter the Control screen. If successful, you’ll see the lights come on, followed by audio instructions to attempt to re-pair the device again. Once the cap is removed, hold down the reset button for 10 seconds. Doing so will turn off the power to the floodlight.) Next, remove the screws leading the micro-SD card slot and reset button. (DO NOT disconnect the attached power wires. Unscrew the top part of the camera piece and very carefully detach it from the floodlight. ![]() However, if the device is disconnected from the internet you may also reset the device by opening the camera on the Aria floodlight. The device will still be linked to your account with either method.ī. A ‘Restart’ will allow you to retain the same settings, but a ‘Reset’ will wipe the connection and Wi-Fi settings. Go to the Aria’s ‘GENERAL’ settings screen and tap the ‘Restart’ button for a simple power reboot or tap the ‘Reset to Factory Settings’ if you want to perform a total reset. If the Aria is still connected to the internet, you may restart/reset the device from the app. Connect the other ends to the terminals on the back of the Garage Door Controller (making sure you insert on the first two inner terminals).Ī. If you’re still unsure about which terminals to be connecting the wires to, feel free to browse through our picture guide for your garage opener model. Connect the provided wires into the terminals. Next, identify the correct terminals on your garage opener, which are the same ones used for your wall remote console. Once you have successfully connected the device to your Momentum account, mount the device under your garage opener using the provided sticker or sticker + metal plate. Make sure to have your volume up and your mobile device close to the Garage Door Controller while pairing.Ģ. Select the “Momentum Garage Door Controller w/ Camera” option, and follow the on screen prompts to complete the pairing process. Download the "Momentum Camera" app and create a new user account. Make sure to have a stable Wi-Fi connection in the area before you proceed. First, connect the USB cable to the device and power source nearby your garage opener. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |